Suzuki WagonR+ RB310 Service Manual page 1157

7B1-192 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
"A"
46) Remove sealant attached to mating surface of transaxle rear
cover (1) completely.
47) Apply sealant to mating surface of transaxle rear cover (1) by
using a nozzle (2) as shown in figure by such amount that its
2
section is 1.2 mm (0.047 in.) in diameter.
"A": Sealant 99000-31230
1
48) Install transaxle rear cover assembly on transaxle case.
49) Install hook (2) to location shown in figure.
Tightening torque
Rear cover bolt
(a): 25 N·m (2.5 kg-m, 18.0 lb-ft)
50) Tighten rear cover bolts (1).
51) Install fluid reservoir LH plate (1).
Tightening torque
Fluid reservoir LH plate bolt
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
52) After applying A/T fluid to new governor apply No.2 gasket
(1), install it to transaxle case.
53) After applying A/T fluid to differential assembly (1) and coun-
tershaft assembly (2), install them to transaxle case.