Suzuki WagonR+ RB310 Service Manual page 1284

7) Calk spindle nut (1).
8) Install spindle cap.
NOTE:
• When installing spindle cap, hammer lightly several
locations on the collar of cap until collar comes closely
into contact with brake drum.
• If fitting part of cap is deformed or damaged or if it is
fitted loosely, replace with new one.
9) Upon completion of all jobs, depress brake pedal with about
30 kg (66 lbs) load at least 15 – 20 times until adjuster actu-
ator clicking sound from drum brake can not be heard so as
to obtain proper drum-to-shoe clearance.
Adjust parking brake cable. (For adjustment, see PARKING
BRAKE INSPECTION AND ADJUSTMENT in SECTION 5.)
10) Install console box if removed.
11) Install wheel and tighten wheel nuts so specified torque.
Tightening torque
(b) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
12) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
Brake Shoe
REMOVAL
1) Perform steps 1) to 5) of BRAKE DRUM REMOVAL.
2) Remove adjuster spring (1).
3) Remove retractor spring (2) as shown.
PARKING AND REAR BRAKE 5C-7