Suzuki WagonR+ RB310 Service Manual page 1684

Clutch release shaft
Check clutch release shaft and its pin for deflection or damage.
If abnormality is found, replace it.
INSTALLATION
1) Drive in a new No.1 bush (1) by using special tools and then
apply grease to bush inside.
Special tool
(A) : 09930-30104
(B) : 09923-46030
"A" : Grease 99000-25010
2) Install release shaft with return spring applied to it.
3) Apply grease to No.2 bush (1) inside and press-fit it by using
the same special tool as in removal.
"A" : Grease 99000-25010
Special tool
(C) : 09922-46010
4) Coat grease to shaft seal (2) lip and then install it till it is flush
with case surface. Use special tool for this installation and
face seal lip downward (inside).
"A" : Grease 99000-25010
Special tool
(D) : 09925-98221
5) Caulk seal at A by using caulking tool and hammer.
CLUTCH 7C-3