Suzuki WagonR+ RB310 Service Manual page 1148

AUTOMATIC TRANSAXLE (M13 ENGINE MODEL) 7B1-183
12) Install 1st and reverse brake plate snap ring so that its both
ends would be positioned in correct locations as shown in
figure.
[A] Correct
[B] Incorrect
13) Using special tools, measure 1st and reverse brake piston
stroke when compressed air (400 – 800 kPa, 4 – 8 kg/cm
57 – 113 psi) is brown through oil hole.
Special tool
(A) 09900-20607
(B) 09900-20701
(C) 09952-06020
1st and reverse brake piston stroke
Standard: 0.791 – 1.489 mm (0.0311 – 0.0586 in.)
14) Install reduction drive gear (1) to transaxle case (3) by using
special tools and hydraulic press.
CAUTION:
• Do not use transaxle case as groundwork to press fit
reduction drive gear.
• Do not give load more than 20 kN (2,000 kg, 4410 lb)
with hydraulic press. Otherwise, it may result in dam-
aging reduction drive gear bearing.
Special tool
(A): 09951-18210
(B): 09944-78210
2. Stand that can slightly lift transaxle case.
NOTE:
When replacing reduction drive gear, replace it together
with reduction driven gear as a set.
2
,