Suzuki WagonR+ RB310 Service Manual page 1563

10B-72 AIR BAG SYSTEM
1
2
AIR BAG WIRE HARNESS AND CONNECTOR IN FLOOR
WIRE HARNESS
Air bag wire harness is included in instrument panel harness. The
part of coupler side wire harness can be identified easily as it is
covered with a yellow protection tube. Be very careful when han-
dling it.
• When an open in air bag wire harness (in floor harness) (1),
damaged wire harness, connector or terminal is found,
replace wire harness, connectors and terminals as an
assembly.
• When installing it, be careful so that the air bag wire harness
(in instrument panel harness) (1) is not caught or does not
interfere with other parts.
• Make sure air bag system grounding point (2) are clean and
grounds are securely fastened for optimum metal-to-metal
contact. Poor grounding can cause intermittent problems
that are difficult to diagnose.
Disposal
Do not dispose of the live (undeployed) air bag (inflator) modules
and the live (inactivated) seat belt pretensioners. When disposal
is necessary, be sure to deploy/activate the air bag and seat belt
pretensioner according to deployment/activation procedure
described in "AIR BAG (INFLATOR) MODULE AND SEAT BELT
PRETENSIONER DISPOSAL" in this section.
WARNING:
Failure to follow proper air bag (inflator) module and seat
belt pretensioner disposal procedures can result in air
bag deployment and pretensioner activation which could
cause personal injury. Undeployed air bag (inflator) mod-
ule and inactivated seat belt pretensioner must not be
disposed of through normal refuse channels.
The undeployed air bag (inflator) module and inactivated
seat belt pretensioner contain substances that can cause
severe illness or personal injury if the sealed container is
damaged during disposal.