Suzuki WagonR+ RB310 Service Manual page 1345

0A-2 GENERAL INFORMATION
6
1
5
8
2
7
3
4
8
7
4
Precautions
Precaution for Vehicles Equipped with a Sup-
plemental Restraint (Air Bag) System
WARNING:
• The configuration of air bag system parts are as shown
in the figure. When it is necessary to service (remove,
reinstall and inspect) these parts, be sure to follow
procedures described in Section 10B. Failure to follow
proper procedures could result in possible air bag sys-
tem activation, personal injury, damage to parts or air
bag system being unable to activate when necessary.
• If the air bag system and another vehicle system both
need repair, SUZUKI recommends that the air bag sys-
tem be repaired first, to help avoid unintended air bag
system activation.
• Do not modify the steering wheel, dashboard, or any
other air bag system components. Modifications can
adversely affect air bag system performance and lead
to injury.
• If the vehicle will be exposed to temperatures over
93°C (200°F) (for example, during a paint baking pro-
cess), remove the air bag system components before-
hand to avoid component damage or unintended air
bag system activation.
1. Air bag wire harness (in instrumental
panel harness)
2. Passenger air bag (inflator) module (if
equipped)
3. SDM
4. Seat belt pretensioner
Diagnosis
• When troubleshooting air bag system, be sure to follow
"DIAGNOSIS" in Section 10B. Bypassing these procedures
may result in extended diagnostic time, incorrect diagnosis,
and incorrect parts replacement.
• Never use electrical test equipment other than that specified
in this manual.
WARNING:
Never attempt to measure the resistance of the air bag
(inflator) modules (driver, passenger and side) and seat
belt pretensioners (driver and passenger). It is very dan-
gerous as the electric current from the tester may deploy
the air bag or activate the pretensioner.
5. Contact coil
6. Driver air bag (inflator) module
7. Side air bag (inflator) module
(if equipped)
8. Side sensor (if equipped)