Suzuki WagonR+ RB310 Service Manual page 1432

(A)
4) Depress foot brake fully, run engine at idle and stall then check fluid pressure in "D" or "R" range.
CAUTION:
Do not continue running engine at stall speed longer than 5 seconds.
Line pressure
At idle speed
At stall speed
Test result
Line pressure higher than stan-
dard level in each range
Line pressure lower than standard
level in each rang
Line pressure lower than standard
level only in "D" range
Line pressure lower than standard
level only in "R" range
Line pressure test
Purpose of this test is to check operating conditions of each part
by measuring fluid pressure in fluid pressure line.
Line pressure test requires following conditions.
• Automatic fluid is at normal operating temperature (70 –
80°C /158 – 176°F).
• Fluid is filled to proper level (between FULL and LOW on dip-
stick).
1) Apply parking brake securely and place chocks against
wheels.
2) Remove fluid pressure check hole plug bolt.
3) Attach oil pressure gauge to fluid pressure check hole in
transmission case.
Special tool
(A) : 09925-37811-001
CAUTION:
After attaching oil pressure gauge, check that no fluid
leakage exists.
"D" range
2
7.6 – 9.2 kg/cm
108.1 – 130.8 psi
2
7.9 – 9.5 kg/cm
112.4 – 135.0 psi
• Malfunctioning regulator valve
• Malfunctioning regulator valve
• Defective oil pump
• Fluid leakage from "D" range pressure circuit
• Fluid leakage from 1st & 2nd brake
• Fluid leakage from rear clutch
• Fluid leakage from "R" range pressure circuit
• Fluid leakage from rear clutch
• Fluid leakage from direct clutch
• Fluid leakage from reverse brake
AUTOMATIC TRANSMISSION (4 A/T) 7B-21
"R" range
14.1 – 17.3 kg/cm
200.6 – 246.0 psi
14.4 – 17.6 kg/cm
204.8 – 250.2 psi
Possible cause
2
2