Suzuki WagonR+ RB310 Service Manual page 1664

11) Insert drive shaft joint to differential gear.
CAUTION:
• Be careful not to scratch oil seal lip with drive shaft
joint while inserting.
• Make sure to insert drive shaft joint fully and seat its
snap ring as it was.
• Do not hit joint boot with hammer or the like. Nothing
but hands is allowed to use when inserting joint.
12) Connect ball stud with knuckle and fasten with bolt to specifi-
cation referring to Section 3D of the Service Manual men-
tioned in the FOREWORD of this manual.
13) Connect tie-rod end with knuckle and fasten new nut to spec-
ified torque referring to Section 3D of the Service Manual
mentioned in the FOREWORD of this manual.
14) Install stabilizer mount brackets, fasten bolts to specified
torque referring to Section 3D of the Service Manual men-
tioned in the FOREWORD of this manual.
15) Pour transmission oil and transfer oil as specified and make
sure that oil has been sealed with oil seal.
MANUAL TRANSMISSION 7A-5