7C-4 CLUTCH (G10/M13 ENGINE MODELS)
INSTALLATION
1) Apply grease to cable end hook (1) and also joint pin (2)
before installing cable.
"A": Grease 99000-25010
2) Hook cable end with pedal using screwdriver or long nose
pliers from cabin inside, then join inner cable joint pin in
release lever.
3) Fasten cable with clutch cable outer bolts (1) to dash panel
(2).
Tightening torque
Clutch cable outer bolt (a): 9 N·m (0.9 kg-m, 6.0 lb-ft)
4) Screw in joint nut and adjust clutch pedal free travel referring
to "DIAGNOSIS" in Section 7C of the Service Manual men-
tioned in the "FOREWORD" of this manual.