Suzuki WagonR+ RB310 Service Manual page 1379

5E-24 ANTILOCK BRAKE SYSTEM (ABS)
NOTE:
When the vehicle was operated in any of the following ways, one of these DTCs may be set even when
the sensor is in good condition. If such possibility is suspected, repair the trouble (dragging of brake,
etc.) of the vehicle, clear DTC once and then after performing the driving test as described in Step 2 of
"ABS DIAGNOSIS FLOW TABLE", check whether or not any abnormality exists.
• The vehicle was driven with parking brake pulled.
• The vehicle was driven with brake dragging.
• Wheel spin occurred while driving.
• Wheel(s) was turned while the vehicle was jacked up.
• The vehicle was stuck.
INSPECTION
Step
1 1) Disconnect applicable ABS wheel speed sensor coupler
with ignition switch OFF.
2) Measure resistance between terminals of ABS wheel
speed sensor. Refer to "FRONT WHEEL SPEED SEN-
SOR" and/or "REAR WHEEL SPEED SENSOR" in this
section.
Is measured resistance value as specified?
2 1) Turn ignition switch OFF.
2) Disconnect ABS hydraulic unit/control module connec-
tor.
3) Check for proper connection to ABS control module at
each sensor terminal.
4) If OK, then turn ignition switch ON and measure voltage
between sensor terminal of module connector and body
ground.
Is it 0V?
3 1) Turn ignition switch OFF.
2) Connect ABS wheel speed sensor coupler.
3) Measure resistance between the following points.
• Both ABS hydraulic unit/control module connector termi-
nals of the corresponding sensor.
This check result should be the same as above Step 1.
• Either terminal of wheel speed sensor coupler and body
ground.
This check result should be no continuity.
Are both check results OK?
4 1) Remove applicable ABS wheel speed sensor.
2) Check sensor for damage or foreign material attached.
Is it in good condition?
5 Check front and/or rear sensor ring for the following (remove
rear drum as necessary) :
• Rotor serration (teeth) neither missing nor damaged.
• No foreign material being attached.
• Rotor not being eccentric.
• Wheel bearing free from excessive play.
Are they in good condition?
Action Yes
Go to Step 2. Replace ABS wheel
speed sensor
assembly.
Go to Step 3. ABS wheel speed
sensor circuit
shorted to power.
Go to Step 4. Circuit open or
shorted to ground.
Go to Step 5. Clean, repair or
replace.
Go to Step 6. Clean, repair or
replace.
No