Suzuki WagonR+ RB310 Service Manual page 1191

7D-6 TRANSFER
Transfer oil level/filler and drain plug
Flange nut
Transfer case bolt
Transfer output retainer bolt
Transfer rear mounting bracket bolt
Transfer rear mounting bracket nut
Transfer mounting bolt
Transfer rear mounting bracket No.2 bolt
Transfer to engine stiffener No.1 bolt
Transfer to engine stiffener No.2 bolt
Bevel gear nut
Transfer to transaxle stiffener bolt
4) Tighten transfer to engine stiffener bolts to specified torque.
5) Tighten transfer to transaxle stiffener bolts (1) to specified
Tightening Torque Specification
Fastening part
Tightening torque
Transfer to engine stiffener No.1 bolt
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
Transfer to engine stiffener No.2 bolt
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
torque.
Tightening torque
Transfer to transaxle stiffener bolt
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
2. Transfer
3. Stiffener
4. Transaxle
• Install exhaust No.1 pipe referring to "Exhaust System Com-
ponents" in Section 6K2.
• Install right side drive shaft referring to "Drive Shaft Removal
and Installation" in Section 4A.
• Install propeller shaft referring to "Propeller Shaft Removal
and Installation" in Section 4B.
• Fill transfer with transfer oil referring to "Oil Change" in Sec-
tion 7D of the Service Manual mentioned in the "FORE-
WORD" of this manual.
• Fill transaxle with transaxle oil referring to "Manual Transaxle
Oil Change" in Section 7A2.
N•m
21
100 – 300
23
50
55
55
55
55
50
23
150
50
Tightening torque
kg-m lb-ft
2.1 15.5
10.0 – 30.0 72.5 – 217.0
2.3 17.0
5.0 36.5
5.5 40.0
5.5 40.0
5.5 40.0
5.5 40.0
5.0 36.5
2.3 17.0
15.0 108.5
5.0 36.5