Suzuki WagonR+ RB310 Service Manual page 1023

7B1-58 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
DTC P0713 Transmission Fluid Temperature Sensor Circuit High
Wiring Diagram
1. TCM
2. Transmission fluid temperature sensor
DTC Detecting Condition and Trouble Area
DTC DETECTING CONDITION
• Transmission temperature sensor terminal voltage is
more than 4.6 V and shift range is in "R", "D", "2" or "L"
for 15 minutes after starting engine.
DTC Confirmation Procedure
WARNING:
• When performing a road test, select a place where there is no traffic or possibility of a traffic acci-
dent and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out with 2 persons, a driver and tester, on a level road.
1) Connect scan tool to DLC with ignition switch OFF if available.
2) Clear DTC in TCM memory and start engine.
3) Start vehicle and increase vehicle speed to about 40 km/h (25 mile/h) for 20 minutes or more.
4) Stop vehicle and check DTC.
1
5V
E13-11
E13-12
[A]
E13
12 11
3. A/T
4. Valve body connector
2
GRN
BLU/RED
E12
[A]: Terminal arrangement of TCM connector (viewed from harness side)
TROUBLE AREA
• Transmission fluid temperature sensor or its cir-
cuit malfunction.
• TCM
3