Suzuki WagonR+ RB310 Service Manual page 1132

AUTOMATIC TRANSAXLE (M13 ENGINE MODEL) 7B1-167
3) Tighten final gear bolts (1) to specified torque.
Tightening torque
Final gear bolt
(a): 78 N·m (7.8 kg-m, 56.5 lb-ft)
2. Final driven gear
NOTE:
• To avoid rust, apply A/T fluid to final driven gear after
installation.
4) After applying A/T fluid to output shaft speed sensor (VSS)
drive gear (1), install output shaft speed sensor drive gear.
5) Install new differential side RH bearing (1) by using special
tool and hydraulic press.
Special tool
(A): 09913-70123
NOTE:
Replace differential side RH bearing together with bear-
ing cup as a set.
6) Install new differential side LH bearing (1) by using special
tool and hydraulic press.
Special tool
(A): 09913-70123
NOTE:
Replace differential side LH bearing together with bear-
ing cup as a set.