5E-36 ANTILOCK BRAKE SYSTEM (ABS)
INSTALLATION
1) Check that no foreign material is attached to sensor (1) and
sensor ring (2).
2) Install it by reversing removal procedure.
Tightening torque
Front wheel speed sensor bolt
(a) : 10 N·m (1.0 kg-m, 7.5 lb-ft)
CAUTION:
Do not pull or twist wire harness more than necessary
when installing front wheel speed sensor.
3) Check that there is no clearance between sensor and
knuckle.
Front Wheel Speed Sensor Ring
NOTE:
The front wheel sensor ring can not be removed or
replaced alone. If front wheel sensor ring needs to be
replaced, replace it as a wheel side joint assembly of
drive shaft.
For removal and installation of wheel side joint assembly of drive
shaft, refer to "FRONT DRIVE SHAFT" section.