Suzuki WagonR+ RB310 Service Manual page 1427

7B-16 AUTOMATIC TRANSMISSION (4 A/T)
8. Automatic Transmission Basic Check and Trouble Diagnosis Table
Perform basic automatic transmission check according to the list below first. When the end of the list has been
reached, check the part of system suspected as a possible cause referring to "TROUBLE DIAGNOSIS TABLE"
and based on symptoms appearing on vehicle (symptoms obtained through steps of customer complaint analy-
sis, trouble symptom confirmation and/or A/T basic check) and repair or replace faulty parts, if any.
AUTOMATIC TRANSMISSION BASIC CHECK LIST
1) Power Supply Voltage Check
Check that the battery voltage is within 10 – 14 V at engine stop.
2) A/T Fluid Check
Check A/T fluid level and quality.
3) STALL TEST
Perform stall test. Refer to "STALL TEST" in this section for details.
4) LINE PRESSURE TEST
Perform line pressure test. Refer to "LINE PRESSURE TEST" in this section.
5) ROAD TEST
Perform road test to understand correctly the trouble area.
6) Electrical Harness and Coupler Check
Check the connection of the harness coupler. Check for the loose connection of the harness, loose connec-
tion of the terminals.
9. Diagnostic Trouble Code Flow Table
Based on the DTC indicated in STEP 6 and STEP 7 and referring to "DTC CHECK", locate the cause of the
trouble, namely in a sensor, switch, wire harness, connector, actuator, TCM or other part and repair or replace
faulty parts.
10. Check for Intermittent Problem
Check parts where an intermittent trouble is easy to occur (e.g. wire harness, connector, etc.), referring to
"INTERMITTENT AND POOR CONNECTION" in Section 0A and related circuit of DTC recorded in Step 2.
11. Final Confirmation Test
Confirm that the problem symptom has gone and the automatic transmission is free from any abnormal condi-
tions. If what has been repaired is related to the malfunction DTC, clear the DTC once and perform test driving
and confirm that a normal code is indicated.