Suzuki WagonR+ RB310 Service Manual page 1318

(a)
(b)
[A] : RH
[B] : LH
INSTALLATION
1) Install hydraulic unit by reversing removal procedure.
Tightening torque
(a) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
(b) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
(c) : 26 N·m (2.6 kg-m, 18.0 lb-ft)
2) Bleed air from brake system referring to "BRAKE" section.
3) Check each installed part for fluid leakage and perform "ABS Hydraulic Unit Operation Check" in this sec-
tion.
NOTE:
For new ABS hydraulic unit/control module assembly, if "ABS Hydraulic Unit Operation Check" proce-
dure has not been performed, "ABS" warning lamp may flash when ignition switch is turned ON posi-
tion.
(a)
[A]
3
(c)
ANTILOCK BRAKE SYSTEM (ABS) 5E-27
[B]
(b)
(c)
(b)
3