Suzuki WagonR+ RB310 Service Manual page 1118

AUTOMATIC TRANSAXLE (M13 ENGINE MODEL) 7B1-153
3) Remove balancer snap ring by using special tool and
hydraulic press.
CAUTION:
Do not press forward clutch return spring subassembly
in over 1.5 mm (0.059 in.).
Excessive compression may cause damage to return
spring subassembly and/or balancer.
Special tool
(A): 09926-97610
4) Remove forward clutch balancer (1).
5) Remove forward clutch return spring subassembly (1).
2. Intermediate shaft subassembly
6) Install intermediate shaft subassembly (1) to transaxle rear
cover (2). Apply compressed air (400 – 800 kPa, 4 – 8 kg/
2
cm , 57 – 113 psi) to oil hole (3) of transaxle rear cover to
remove forward clutch piston (4).
7) Apply compressed air (400 – 800 kPa, 4 – 8 kg/cm
113 psi) to oil hole (1) of transaxle rear cover to remove for-
ward clutch drum (2).
2
, 57 –