Suzuki WagonR+ RB310 Service Manual page 1288

Brake Back Plate
REMOVAL
1) Perform steps 1) to 5) of BRAKE DRUM REMOVAL in this
section.
2) Perform steps 2) to 4) of BRAKE SHOE REMOVAL in this
section.
3) Perform steps 3) and 4) of WHEEL CYLINDER REMOVAL in
this section.
4) Remove parking brake cable securing clip (1) and discon-
nect brake cable (2) from brake back plate (3).
5) Remove brake back plate (1) from rear axle.
INSTALLATION
1) Apply water tight sealant to mating surfaces of brake back
plate and rear axle.
"A" : Sealant 366E, 99000-31090
NOTE:
In case of vehicle equipped with ABS, do not apply seal-
ant around hole for wheel speed sensor.
2) Install brake back plate and tighten back plate bolts to speci-
fied torque.
Tightening torque
(a) : 24 N·m (2.4 kg-m, 17.5 lb-ft)
PARKING AND REAR BRAKE 5C-11