Suzuki WagonR+ RB310 Service Manual page 1287

5C-10 PARKING AND REAR BRAKE
Wheel Cylinder
REMOVAL
1) Perform steps 1) to 5) of BRAKE DRUM REMOVAL.
2) Perform steps 2) to 4) of BRAKE SHOE REMOVAL.
3) Loosen brake pipe flare nut but only within the extent that
fluid does not leak.
4) Remove wheel cylinder mounting bolts (1). Disconnect brake
pipe from wheel cylinder and put wheel cylinder bleeder plug
cap (2) onto pipe to prevent fluid from spilling.
INSPECTION
Inspect wheel cylinder disassembled parts for wear, cracks, cor-
rosion or damage.
NOTE:
Clean wheel cylinder components with brake fluid.
INSTALLATION
1) Take off bleeder plug cap from brake pipe and connect pipe
(for pipes) to wheel cylinder just enough to prevent fluid from
leaking.
2) Tighten wheel cylinder (1) to brake back plate (2) to specified
torque.
3) Torque flare nut (3) of brake pipe (4) which was connected in
step 1) to specification.
Tightening torque
(a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
(b) : 16 N·m (1.6 kg-m, 12.0 lb-ft)
4) Install bleeder plug cap taken off from pipe back to bleeder
plug.
5) For procedure hereafter, refer to steps 1) to 6) of BRAKE
SHOE INSTALLATION.
NOTE:
Be sure to bleed brake system. (for bleeding operation,
see BLEEDING BRAKES in SECTION 5.)