Suzuki WagonR+ RB310 Service Manual page 754

• Timing chain cover (1) and cylinder head (2) mating surface
as shown.
"A": Sealant 99000-31250
3) Install cylinder head cover to cylinder head.
NOTE:
When installing cylinder head cover, use care so that cyl-
inder head cover gasket or spark plug hole gaskets will
not get out of place or fall off.
4) Tighten bolts in such order as indicated in figure a little at a
time till they are tightened to specified torque.
Tightening torque
Cylinder head cover bolt
(a): Tighten 5.0 N·m (0.5 kg-m, 3.5 lb-ft),
7.5 N·m (0.75 kg-m, 5.5 lb-ft) by the specified procedure.
5) Connect PCV hose (2) to PCV valve (1).
6) Connect breather hose (4).
7) Install oil level gauge (3).
8) Install wire harness clamp to cylinder head cover.
9) Install ignition coil assemblies with high-tension cord.
10) Connect ignition coil couplers and clamp harness securely.
11) Install cylinder head upper cover.
12) Install air cleaner case and resonator.
13) Connect negative cable at battery.
ENGINE MECHANICAL (M13 ENGINE) 6A2-19