Suzuki WagonR+ RB310 Service Manual page 925

7A2-6 MANUAL TRANSAXLE (M13 ENGINE MODEL)
On-Vehicle Service
CAUTION:
Do not reuse circlip, spring pin, E-ring, oil seal, gasket,
self locking nut and specified parts. Reuse of it can result
in trouble.
Manual Transaxle Oil Change
1) Before changing or inspecting oil, be sure to stop engine and
lift vehicle horizontally.
2) With vehicle lifted up, check oil level and leakage.
If leakage exists, correct it.
3) Drain old oil and fill new specified oil by specified amount (up
to level hole).
4) Apply sealant to thread of drain plug (2) and level/filler plug
(3) and torque them as specified below.
"A": Sealant 99000-31260
Tightening torque
Transaxle oil level/filler and drain plugs
(a): 21 N·m (2.1 kg-m, 15.5 lb-ft)
NOTE:
• It is highly recommended to use API GL-4 75W-90 gear
oil.
• Whenever vehicle is hoisted for any other service work
than oil change, also be sure to check for oil leakage.
Transaxle oil
: API GL-4
For SAE classification, refer to viscosity chart [A] in the
figure.
Transaxle oil capacity
: 2.2 liters (4.6/3.9 US/lmp. pt)
1. Drive shaft (LH)
Differential Side Oil Seal Replacement
Replacement
1) Lift up vehicle and drain transaxle oil.
2) Remove front drive shafts referring to "Drive Shaft Assembly
Removal and Installation" in Section 4A.
3) Separate transfer from transaxle assembly. (for 4WD vehicle)
For detail, refer to "Transfer Dismounting and Remounting" in
Section 7D.