Suzuki WagonR+ RB310 Service Manual page 1624

REMOVAL
1) Hoist vehicle.
2) Before removing propeller shafts, give match marks (1) on
yoke (3) of propeller shaft No.2 (4) and companion flange (2)
of differential as shown. Also give match marks (1) on pro-
peller shaft No.2 yoke (5), viscous coupling with center sup-
port (6), yoke (7) of propeller shaft No.1 with center support
(8) and transfer output flange (9).
CAUTION:
Don't damage joint seal (10) to prevent lubrication defect
of joint.
3) Loosen propeller shaft bolt at front and rear end, and sepa-
rate propeller shafts from transfer and rear differential.
4) If disassembling propeller shaft assembly is necessary,
loosen propeller shaft No.2 bolts (1) and viscous coupling
nuts (2) to facilitate subsequent disassembling, but keeping
each connection provisionally.
PROPELLER SHAFTS 4B-3