Suzuki WagonR+ RB310 Service Manual page 1537

10B-46 AIR BAG SYSTEM
DTC B1061 – "AIR BAG" Warning Lamp Circuit Failure
WIRING DIAGRAM
1
1. From main fuse
2. Ignition switch
3. "METER" fuse
4. "AIR BAG" warning lamp in combination meter
CAUTION:
• Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according to
flow table.
• When measurement of resistance or voltage is required in this table, use a specified digital multim-
eter (refer to SPECIAL TOOL in this section.) along with a correct terminal adapter from special tool
(Connector test adapter kit).
• When a check for proper connection is required, refer to INTERMITTENTS AND POOR CONNEC-
TIONS in this section.
• If there is open circuit in the air bag wire harness (in instrument panel harness), connector or termi-
nal is found damaged, replace the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN
The voltage at the "AIR BAG" warning lamp circuit terminal "G66-30" does not match the commanded state of
the warning lamp driver for specified time.
TABLE TEST DESCRIPTION
STEP 1 : This test rechecks "AIR BAG" warning lamp operation.
STEP 2 : This test rechecks whether an abnormality is in SDM.
3
BLK/RED
GRN
2
GRN
5
1
WHT/BLU
7
BLK
10
BRN
8
5. "AIR BAG" fuse
6. SDM
7. To DLC
8. Ground on engine block
"G66"
"G25"
"G25"
BLU
G66-30
BLK
G66-31
9
4
BLU/RED
G66-32
WHT/RED
G66-28
6
+30V+5V
9. Ground for air bag system
10. Ground on body