Suzuki WagonR+ RB310 Service Manual page 1502

Air Bag Diagnostic System Check Flow Table
Step Action
1 1) Make sure that battery voltage is
about 11 V or higher.
2) Note "AIR BAG" warning lamp as
ignition switch is tuned ON.
Does "AIR BAG" warning lamp come
ON when ignition switch is tuned
ON?
2 Does "AIR BAG" warning lamp come
ON steady?
3 Does "AIR BAG" warning lamp turn
OFF, after flashing 6 times?
4 1) Check DTC using SUZUKI scan
tool. Refer to DTC CHECK in this
section.
Is "NO CODES" displayed on
SUZUKI scan tool?
5 1) Check DTC using SUZUKI scan
tool. Refer to DTC CHECK in this
section.
Is "NO CODES" displayed on
SUZUKI scan tool?
Yes
Go to step 2.
Proceed to "AIR BAG"
Warning Lamp Comes
ON Steady in this section.
"AIR BAG" warning lamp
circuit is good condition.
Go to step 4.
Air bag system is in good
condition.
Substitute a known-good
SDM and recheck.
AIR BAG SYSTEM 10B-11
No
Proceed to "AIR BAG" Warning Lamp
Does Not Come ON in this section.
Go to step 3.
"AIR BAG" warning lamp circuit is
good condition.
Go to step 5.
An intermittent trouble has occurred
at some place.
Check the connector harness, etc.
related to the sensed DTC.
Refer to INTERMITTENTS AND
POOR CONNECTIONS in this sec-
tion.
Then clear DTC (Refer to DTC
CLEARANCE in this section.) and
repeat this table.
Check and repair according to Flow
Table corresponding to that DTC.