Suzuki WagonR+ RB310 Service Manual page 1073

7B1-108 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
[Not using regulated DC power supply]
1) Connect pressure control solenoid valve (1) to battery (2)
setting the 8 – 10 W bulb (4) on the way as shown in the fig-
ure.
2) Check for movement of valve (3) in the direction of arrow "A".
3) Disconnect pressure control solenoid valve (1) from battery
(2) and check for movement of valve (3) in the direction of
arrow "B" as shown in the figure.
CAUTION:
Set 8 – 10 W bulb on the way, or pressure control sole-
noid valve is burned out.
Installation
Reverse removal procedure to install pressure control solenoid
valve and valve body assembly noting the following points.
• For detail of pressure control solenoid valve installation, refer
to "Valve Body Assembly" in this section.
• For detail of valve body assembly installation, refer to "Unit
Assembly" in this section.
• For detail of installing wire harness for solenoid valves and
sensor, refer to "Unit Assembly" in this section. Use new O-
rings.
• For detail of A/T oil pan and oil strainer assembly installation,
refer to "Unit Assembly" in this section. Use new oil pan gas-
ket.
• Pour A/T fluid and check fluid level according to procedure
described in "Fluid Change" in this section.
• Check for fluid leakage after warning up A/T.