Suzuki WagonR+ RB310 Service Manual page 1698

Unit Assembly
CAUTION:
• Bevel gear and pinion must be replaced as a set when
either replacement becomes necessary.
• When replacing taper roller bearing, replace as inner
race & outer race assembly.
Judging from faulty conditions noted before disassembly and
what is found through visual check of bearing and gear tooth etc.
after disassembly, prepare replacing parts and proceed to reas-
sembly according to procedures as described below.
Reduction driven gear assembly
ASSEMBLY
1) Drive in bevel gear to reduction driven gear.
2) Tighten bevel gear nut to specified torque while holding
bevel gear with special tool and vise, and then caulk nut.
Tightening torque
Transfer bevel gear nut
: 150 N·m (15.0 kg-m, 108.5 lb-ft)
Special tool
(B) : 09941-58020
(C) : 09924-57610
NOTE:
Support shaft with special tool as illustrated in the figure
so that retainer of bearing cone will be free from com-
pression.
3) Press-fit driven gear bearings (2) (right and left) to driven
gear by using special tools.
Special tool
(A) : 09945-16070
1. Plate
TRANSFER 7D-11