Scan Tool Data - Suzuki WagonR+ RB310 Service Manual

Scan Tool Data

As the data values given below are standard values estimated on the basis of values obtained from the normally
operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good condi-
tion, there may be cases where the checked value does not fall within each specified data range. Therefore,
judgment as abnormal should not be made by checking with these data alone.
Also, condition in the below table that can be checked by the scan tool are those detected by TCM and output
from TCM as commands and there may be cases where the automatic transaxle or actuator is not operating (in
the condition) as indicated by the scan tool.
NOTE:
The following scan tool data related to automatic transaxle can be checked only by communicating
with TCM.
SCAN TOOL DATA
GEAR POSITION Ignition switch ON
ENGINE SPEED At engine idle speed
INPUT SHAFT Ignition switch ON and engine stop
REVOLUTION
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
("D" range)
OUTPUT SHAFT At vehicle stop
REVOLUTION
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
BATTERY VOLT- Ignition switch ON and engine stop
AGE
ATF TEMPERA- After driving at 60 km/h (37.5 mile/h) for 15 minutes or
TURE more, and A/T fluid temperature around sensor
reaches 70 – 80°C (158 – 176°F)
SHIFT SOLENOID- At vehicle stop
A COMMAND
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
SHIFT SOLENOID- At vehicle stop
A MONITOR
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
SHIFT SOLENOID- At vehicle stop
B COMMAND
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
SHIFT SOLENOID- At vehicle stop
B MONITOR
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
TIMING SOLE- Ignition switch ON and selector lever is in "N" range
NOID COMMAND
For about 0.5 sec. while on gear shifting between 3rd
and 4th or gear shifting N to D
VEHICLE CONDITION
Selector lever is in "P" position
Selector lever is in "R" position
Selector lever is in "N" position
Selector lever is in "D" position
Selector lever is in "2" position
Selector lever is in "L" position
AUTOMATIC TRANSAXLE (M13 ENGINE MODEL) 7B1-83
NORMAL CONDITION/REFER-
ENCE VALUES
Engine idle speed is displayed
2,600 RPM
(displayed in increments of 50
2,600 RPM
(displayed in increments of 50
Battery voltage is displayed
70 – 80°C, 158 – 176°F
P or N
R
P or N
1
1
1
0 RPM
rpm)
0 RPM
rpm)
(8 – 16 V)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON