Suzuki WagonR+ RB310 Service Manual page 1123

7B1-158 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
• Install reverse clutch plate snap ring so that its both ends
would be positioned in correct locations as shown in figure.
[A]: Correct
[B]: Incorrect
• Measure reverse clutch piston stroke in the same manner as
"Preliminary Check".
Special tool
(A): 09900-20607
(B): 09900-20701
Reverse clutch piston stroke: 1.20 – 1.60 mm (0.047 –
0.063 in.)
When piston stroke is out of specification, select reverse clutch
retaining plate with proper thickness from among the list below
and replace it.
Available reverse clutch retaining plate thickness
Thickness
3.0 mm (0.118 in.)
3.2 mm (0.126 in.)
3.4 mm (0.134 in.)
3.6 mm (0.142 in.)
Identification mark
1
2
3
4