Suzuki WagonR+ RB310 Service Manual page 1539

10B-48 AIR BAG SYSTEM
DTC B1063 – Side Sensor (Driver Side) Circuit Short to Ground
DTC B1064 – Side Sensor (Driver Side) Circuit Short to Power Circuit Or Open
DTC B1065 – Side Sensor (Passenger Side) Circuit Short to Ground
DTC B1066 – Side Sensor (Passenger Side) Circuit Short to Power Circuit or
Open
WIRING DIAGRAM
1
1. From main fuse
2. Ignition switch
3. "AIR BAG" fuse
CAUTION:
• Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according to
flow table.
• When measurement of resistance or voltage is required in this table, use a specified digital multim-
eter (refer to SPECIAL TOOL in this section.) along with a correct terminal adapter from special tool
(Connector test adapter kit).
• When a check for proper connection is required, refer to INTERMITTENTS AND POOR CONNEC-
TIONS in this section.
• If there is open circuit in the air bag wire harness (in instrument panel harness), connector or termi-
nal is found damaged, replace the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN
DTC B1063 or B1065 :
The voltage measured at side sensor (driver or passenger side) circuit is below a specified value for specified
time.
DTC B1064 or B1066 :
The voltage measured at side sensor (driver or passenger side) circuit is above a specified value for specified
time.
3
GRN
2
5
6
4. SDM
5. Side sensor (driver side)
6. Side sensor (passenger side)
"G66"
BLU/RED
G66-32
"G68"
GRN/WHT
G66-17
GRN/BLK
G66-6
"G71"
GRN/YEL
G66-16
GRN/ORN
G66-5
BLK
G66-31
7
7. Ground for air bag system
4