Renault Laguna III Manual page 1521

Engine cooling fan assembly: Removal - Refitting
V9X
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights),
- the audible warning (see Audible warning: Re-
moval - Refitting) (82B, Horn),
- the bonnet catch (see Bonnet lock: Removal -
Refitting) (52A, Non-side opening element mecha-
nisms),
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure).
a Unclip the engine cooling fan assembly wiring (1) .
a Move aside the engine cooling fan assembly wiring.
COOLING
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the engine cooling fan assembly con-
nectors (2) .
a Unclip the engine cooling fan assembly wiring.
a Move aside the engine cooling fan assembly wiring.
a Unclip the fuel drain pipe (3) .
a Unclip the engine cooling fan assembly from the ra-
diator at (4) by pushing it upwards to detach the
brackets holding it.
a Remove the engine cooling fan assembly upwards.
137901
19A-133
19A
137900
134210