Tyre Pressure Monitoring System - Renault KADJAR 2021 Vehicle User Manual

TYRE PRESSURE MONITORING SYSTEM

1 3
2
If the vehicle is equipped with the func-
tion, this system monitors the tyre pres-
sure.
Operating principle
Each wheel (except for the emergency
spare wheel) has a sensor in the infla-
tion valve which periodically measures
the tyre pressure.
The system displays the current pres-
sures on the instrument panel 1 and
alerts the driver in the event of insuffi-
cient pressure.
(1/3)
Resetting the standard level
for the tyre pressures
This should be done:
– when the standard tyre pressure
needs to be changed to adapt to
usage conditions (empty, carrying a
load, motorway driving, etc.);
– after swapping a wheel (however
this practice is not recommended);
– after changing a wheel.
It should always be done after checking
the tyre pressure of all four tyres when
cold.
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving, etc.).
Resetting can also be done from the
multifunction screen 3 if your vehi-
cle is fitted with a navigation system.
Select "Vehicle", "Tyre pressure".
Resetting procedure
With the ignition on:
– repeatedly and briefly press control 2
to select the tyre pressure display
and the "Tyre pressure" function;
– press and hold (around 3 seconds)
the button 2 to launch the reset. The
flashing tyres followed by the mes-
sages "Learning TP initiated" and
then "Tyres location in progress" in-
dicates that the reset request for the
tyre pressure reference value has
been acknowledged.
Reset can take several minutes of driv-
ing.
If the resetting is followed by short
trips, the message "Tyres location in
progress" can remain displayed after
successive restarts.
Note
The standard tyre pressure cannot be
less than that recommended and indi-
cated on the door frame.
2.29