Danfoss VLT AutomationDrive Design Manual page 4

Contents
6.1.1 Safety Requirements of Mechanical Installation
6.1.2 Mechanical Mounting
7 Mechanical Installation - Frame size D, E and F
7.1 Pre-installation
7.1.1 Planning the Installation Site
7.1.2 Receiving the Frequency Converter
7.1.3 Transportation and Unpacking
7.1.4 Lifting
7.1.5 Mechanical Dimensions
7.1.6 Mechanical Dimensions, 12-Pulse Units
7.2 Mechanical Installation
7.2.1 Tools Needed
7.2.2 General Considerations
7.2.3 Terminal Locations - Frame size D
7.2.4 Terminal Locations - Frame size E
7.2.5 Terminal Locations - Frame size F
7.2.6 Terminal Locations, F8-F13 - 12-Pulse
7.2.7 Cooling and Airflow
7.2.8 Installation on the Wall - IP21 (NEMA 1) and IP54 (NEMA 12) Units
7.2.9 Gland/Conduit Entry - IP21 (NEMA 1) and IP54 (NEMA12)
7.2.10 Gland/Conduit Entry, 12-Pulse - IP21 (NEMA 1) and IP54 (NEMA12)
7.2.11 IP21 Drip Shield Installation (Frame size D1 and D2 )
8 Electrical Installation
8.1 Connections- Frame Sizes A, B and C
8.1.1 Removal of Knockouts for Extra Cables
8.1.2 Connection to Mains and Earthing
8.1.3 Motor Connection
8.1.4 Relay Connection
8.2 Connections - Frame Sizes D, E and F
8.2.1 Torque
8.2.2 Power Connections
8.2.3 Power Connections 12-Pulse Drives
8.2.4 Shielding against Electrical Noise
8.2.5 External Fan Supply
8.3 Fuses and Circuit Breakers
8.3.1 Recommendations
8.3.2 CE Compliance
8.4 Disconnectors and Contactors
8.4.1 Mains Disconnectors
FC 300 Design Guide
®
MG.33.BD.02 - VLT is a registered Danfoss trademark
117
120
121
121
121
121
121
121
123
130
133
133
133
135
137
142
146
151
152
153
154
156
157
157
158
158
160
168
169
169
169
180
189
189
190
190
191
203
203
3