Motion Control In Sv22 Virtual Mode - Mitsubishi Electric Q172CPU Programming Manual

1 OVERVIEW

1.3 Motion Control in SV22 Virtual Mode

<PLC CPU>
PLC program
SP.SFCS
Motion SFC
program start
request instruction
(Note) : Motion SFC program can also be started automatically
by parameter setting.
• Home position return data is not used, since home position return cannot be executed in virtual mode.
(Home position return is executed in real mode.)
• JOG operation in virtual mode is controlled using the JOG operation data set by drive module parameters.
(1) Synchronous control with software is performed using the mechanical system
program comprised by virtual main shaft and mechanical module in (SV22) virtual
mode.
(2) Mechanical system programs is required in addition to the positioning parameter,
servo program/Motion SFC program used in real mode.
(3) The procedure of positioning control in virtual model is shown below:
1) Motion SFC program for virtual mode is requested to start using the S(P).
SFCS instruction of the PLC program.
(Motion SFC program can also be started automatically by parameter setting.)
2) The virtual servomotor of the mechanical system program is started.
3) Output the operation result obtained through the transmission module to the
servo amplifier set as the output module.
4) The servomotor is controlled.
Program structure in SV22 virtual mode
1)
K0
•••• •••• ••••
Specification of starting
program No.
<Motion CPU>
Motion SFC program
Transfer
[G200]
M2044//on virtual mode?
Servo program
[K100: virtual]
1 VF
Axis 1,
Speed # 0 PLS/s
END
Positioning control parameters
System settings
Fixed parameters
Servo parameters
Parameter blocks
Limit switch output data
1 - 4
Mechanical system program
Drive module
(Virtual servomotor)
Transmission module
2)
(Axis 1)
Output module
3)
Servo amplifier
4)
Servomotor
3)
Servo amplifier
4)
Servomotor