Figure 5-10. NO
Converter Assembly
2
Wrap the band heater around the new replacement converter cartridge and
tighten the screws using a high-temperature anti-seize agent (Teledyne API P/N
CH42) such as copper paste.
o
Ensure to use proper alignment of the heater with respect to the converter tubes.
Replace the Moly converter assembly by routing the cables through the holes in
the converter housing and reconnecting them properly.
Reconnect the steel cable clamp around the power leads for safe operation.
Reattach the tube fittings to the converter and replace the Moly insulation (top
layer and corner cut out layers).
Reinstall the converter assembly cover.
083730200A DCN7962
Teledyne API T200 NO/NO
/NO
Analyzer with NumaView™ Software
123
2
x