Setup>Digital Outputs; Figure 2-51. Digital Outputs Setup - Teledyne T200 User Manual

S >D O
ETUP IGITAL UTPUTS
Specify the function of each digital output (connected through the rear panel STATUS
connector) by mapping the output to a selection of "Signals" present in the instrument.
Create custom "Signals" in the Setup>Events menu (Section 2.5.2). (If the Motherboard
Relay Option was installed, the four additional relays can also be mapped).
To map Digital Outputs to Signals, select a pin in the Outputs list, then make a selection
from the Signals list and press the Map button; if/as needed, change the polarity by pressing
the Polarity button. Save any changes by pressing the Apply button, or discard the changes
by pressing the Home or the back button (a pop-up provides a warning that the changes
will be lost, and will prompt for confirmation to apply changes or not).
Go to the Utilities>Diagnostics>Digital Outputs menu to change the state (ON/OFF) of
individual digital outputs.

Figure 2-51. Digital Outputs Setup

083730200A DCN7962 Teledyne API T200 NO/NO /NO Analyzer with NumaView™ Software 73
2 x