Pressure / Flow Sensor Assembly; Figure 5-18. Pressure / Flow Sensor Assembly - Teledyne T200 User Manual

PRESSURE / FLOW SENSOR ASSEMBLY

The flow and pressure sensors are located on a PCA just behind the PMT sensor (see Figure
2-3) can be checked with a voltmeter.
The following procedure assumes that the wiring is intact and that the motherboard and
power supplies are operating properly:
B PCA O
ASIC
• Measure the voltage between TP2 and TP1 C1 it should be 10 VDC ± 0.25 VDC. If
not then the board is bad. Replace the PCA.
156 Teledyne API T200 NO/NO

Figure 5-18. Pressure / Flow Sensor Assembly

C
PERATION HECK
/NO Analyzer with NumaView™ Software
2 x
083730200A DCN7962