Figure 2-18. Gas Line Connections With Z/S Valves Option (Opt 50A) - Teledyne T200 User Manual

VENT if Calibrator not already vented.

Figure 2-18. Gas Line Connections with Z/S Valves Option (OPT 50A)

In addition to tubing, pressure, venting, and exhaust requirements set out in Section 2.3.2.1,
attach the following pneumatic lines:
S G
AMPLE
Attach a sample inlet line to the SAMPLE inlet fitting.
In applications where the sample gas is received from a pressurized manifold, vent
•
the sample gas line.
C
ALIBRATION
SPAN GAS
ZERO AIR
V
ENTING
Vent both the span gas and zero air supply lines.
083730200A DCN7962
MODEL 700
Gas Dilution
Calibrator
MODEL 701
Zero Gas
Generator
S
AS OURCE
G S
AS OURCES
Attach a gas line from the source of calibration gas (e.g. a Teledyne API's T700
Dynamic Dilution Calibrator) to the SPAN1 inlet.
Zero air is supplied by the zero air generator such as a Teledyne API's M701.
Attach a gas line from the source of zero air to the ZERO AIR inlet.
Teledyne API T200 NO/NO
VENT
here if input
is pressurized
PUMP
/NO Analyzer with NumaView™ Software
2 x
Source of
SAMPLE Gas
SAMPLE
EXHAUST
SPAN1
ZERO AIR
41