Table 2-2. Rear Panel Description - Teledyne T200 User Manual

Table 2-2. Rear Panel Description

COMPONENT
cooling fan
AC power
connector
Model/specs label
TO CONV
FROM CONV
MULTI
TO DRYER
FROM DRYER
SAMPLE
EXHAUST
SPAN 1
SPAN2/VENT
ZERO AIR
RX TX
COM 2
RS-232
DCE DTE
STATUS
ANALOG OUT
CONTROL IN
ALARM
ETHERNET
ANALOG IN
USB
Model Label
22 Teledyne API T200 NO/NO
Pulls ambient air into chassis through side vents and exhausts through rear.
Connector for three-prong cord to apply AC power to the analyzer.
CAUTION! The cord's power specifications (specs) MUST comply with the power
specs on the analyzer's rear panel Model number label
Identifies the analyzer model number and provides power specs
(not used)
(not used)
(not used)
(not used)
Outlet for internal sample gas dryer; connect to external zero air scrubber (for IZS options
only).
Connect a gas line from the source of sample gas here.
Calibration gases can also enter here on units without zero/span/shutoff valve options
installed.
Connect an exhaust gas line of not more than 10 meters long here that leads outside the
shelter or immediate area surrounding the instrument. The line must be ¼" tubing or
greater.
On units with zero/span/shutoff valves option installed, connect a gas line to the source of
calibrated span gas here.
On units with pressurized span valve option, used for venting.
Internal Zero Air: On units with zero/span/shutoff valves option installed but no internal zero
air scrubber attach a gas line to the source of zero air here.
LEDs indicate receive (RX) and transmit (TX) activity on the when blinking.
Serial communications port for RS-232 or RS-485.
Serial communications port for RS-232 only.
Switch to select either data terminal equipment or data communication equipment during
RS-232 communication.
For outputs to devices such as Programmable Logic Controllers (PLCs).
For voltage or current loop outputs to a strip chart recorder and/or a data logger.
For remotely activating the zero and span calibration modes.
Option for concentration alarms and system warnings.
Connector for network or Internet remote communication, using Ethernet cable
Option for external voltage signals from other instrumentation and for logging these signals
Connector for direct connection to laptop computer, using USB cable.
Includes voltage and frequency specifications
/NO Analyzer with NumaView™ Software
2 x
FUNCTION
083730200A DCN7962