Menu Overview; Table 2-10. Menu Overview - Teledyne T200 User Manual

MENU OVERVIEW

Table 2-10 describes the main menus and provides cross-references to the respective
sections with configuration details.

Table 2-10. Menu Overview

MENU
Home
Dashboard
Alerts
Calibration
Utilities
Setup
(with valve options)
56 Teledyne API T200 NO/NO
View and plot concentration readings and other selectable parameter
values (Figure 2-34).
View user-selected parameters and their values, some of which can be
displayed in a live-plot graph (Figure 2-35).
View and clear active Alerts that were triggered by factory-defined Events
as well as user-defined Events. (Active and past Alerts are recorded in
the Utilities>Alerts Log).
Run calibrations on the NO and NOx channels and calibrate converter
efficiency points.
View logs, download data and firmware updates, copy configurations
between instruments, and run diagnostics.
Configure a variety of features and functions through these submenus for
customized operation.
Track and record concentration and calibration data and
selectable diagnostic parameters, the reports for which can
be viewed in the Utilities>Datalog View menu (Section 2.4.5)
Datalogging and downloaded to a flash drive via the Utilities>USB Utilities
menu (Section 2.4.5).
Also, select configured Events (Section 2.5.2) and create
customized triggers for data logging functions.
Select parameters and define the conditions by which they
are to be flagged and recorded in the Alerts log (Section
Events
2.4.3) when they are triggered. Once configured, Events can
be used to trigger Datalogs. (Section 2.5.1). Note that some
Events are predefined and are not editable.
Monitor instrument functionality (Figure 2-32) via selectable
Dashboard
parameters.
Auto Cal When zero/span valve options installed, configure
sequences for automatic calibration functions.
Manually adjust several software variables that define
Vars
specific operational parameters.
Homescreen Select up to three parameters to be displayed in the meters
(Figure 2-33).
Map the rear-panel digital outputs to a variety of signals
Digital
present in the instrument to monitor the status of operating
Outputs
conditions or custom Events.
Send user-selected parameter readings in the form of user-
Analog
defined voltage or current loop signals as outputs to a strip
Outputs
chart recorder and/or the data logger.
View product and system information, including list of
options, if any; view network settings; view/adjust Date and
Time settings*; and check for firmware updates when
Instrument
connected to a network that is connected to the Internet.
*
Time Zone change requires special procedures (Section 5.5).
Comm View and configure network and serial communications.
/NO Analyzer with NumaView™ Software
2 x
DESCRIPTION LOCATION
Section 2.4.1
Section 2.4.2
Section 2.4.3
Sections 2.4.4
and 4
Section 2.4.5
Section 2.5
Section 2.5.1
Section 2.5.2
Section 2.5.3
Section 4.3
Section 2.5.5
Section 2.5.6
Section 2.5.7
Section 2.5.8
Section 2.5.9
Section 2.5.10
083730200A DCN7962