Time Zone Changes; Figure 5-5. Time Zone Change Requirements - Teledyne T200 User Manual

TIME ZONE CHANGES

There is an option to change between 12-hour and 24-hour format in the Setup>Vars menu
(System Time Format). Effectively changing the Time Zone requires a specific procedure
as follows:
1. In Setup>Instrument>Date/Time Settings select the applicable Time Zone.
2. Allow adequate time for the selected Time Zone to be properly accepted.
3. Verify: return to Home page then back to the Date/Time Settings page, and
4. Without making any other changes, power OFF the instrument and power ON
5. Once restarted, return to the Date/Time Settings page where the newly
6. After the Time Zone is implemented first (Steps 1 through 5), then other
112 Teledyne API T200 NO/NO
check that the selected Time Zone is now highlighted.
again.
selected Time Zone should be highlighted. (If not, it means that not enough
time had passed for the instrument to accept the change before the power was
cycled OFF).
changes to the date and/or time can be made, and recycling the power is not
necessary.

Figure 5-5. Time Zone Change Requirements

/NO Analyzer with NumaView™ Software
2 x
083730200A DCN7962