Time Switch-Over Function - Simons Voss Technologies SmartRelais 3 Advanced Manual

SimonsVoss
Manual
SmartRelais 3 Advanced

8.11 Time switch-over function

ATTENTION
Assignment of a time
zone plan
Activating time zone
control and time
change-over
4. Click on the OK button.
5. Click on the Yes button.
ð Software reset has been completed.
Unintentional opening due to use with SmartOutput module
The opening behaviour with a SmartOutput module in conjunction with time
zone control deviates from the opening behaviour without the SmartOutput
module.
All relays in the SmartOutput module are switched.
1. See the sections on Extended configuration with SmartOutput modules
[} 94] and Extended configuration without SmartOutput module
[} 93].
The fifth group in the time zone plan is relevant for time change-over.
ü LSM launched.
ü SREL3 ADV System added.
ü Time zone plan added.
1. Double-click on the SmartRelay 3 entry in the matrix to open the
settings.
2. Change to the [Door] tab.
3. Open the Time zone drop-down menu.
4. Select your time zone.
5. Click on the Apply button.
6. Click on the Exit button.
ð Time zone is selected.
Whereas time zone control itself can only influence identification
media authorisations, the time change-over also activates time-
dependent switching of the relay in the controller. Both need to be
activated.
8 | SREL3 ADV in LSM 91 / 135