Resetting The Access List - Simons Voss Technologies SmartRelais 3 Advanced Manual

SimonsVoss
Manual
SmartRelais 3 Advanced

8.2.2 Resetting the access list

8.2.2.1 Resetting the access list with USB cable
Deleting the access list
in the controller
Deleting the access list
in LSM
Programming the con-
troller
8.2.2.2 Resetting the access list over network
Deleting the access list
in the controller
Deleting the access list
in LSM
4. Select the "TCP nodes" item.
5. Click on the Read button.
ð Locking device is read.
ð The "G2 Smart Relay 3" window will open.
6. Click on the Read button.
7. Click on the Audit Trail button.
ð Access list is displayed.
If you wish to delete the access list permanently, you must delete it in LSM
and in the controller. The access list is synchronised between the controller
and LSM and stored in both. The controller features a built-in memory
module for this purpose.
Reset the controller (see Resetting controller with a USB cable [} 29]).
1. Double-click on the entry in the matrix to open the settings for
SmartRelay 3.
2. Change to the [Audit Trail] tab.
3. Click on the Delete Audit Trail button.
4. Press on OK to accept query.
ð Access list is now deleted.
Resetting the controller results in a programming requirement.
Execute programming for the controller (see Programming [} 24]).
Reset the controller (see Resetting controller over the network
[} 31]).
1. Double-click on the entry in the matrix to open the settings for
SmartRelay 3.
2. Change to the [Audit Trail] tab.
3. Click on the Delete Audit Trail button.
8 | SREL3 ADV in LSM 83 / 135