Simons Voss Technologies SmartRelais 3 Advanced Manual page 123

SimonsVoss
Manual
SmartRelais 3 Advanced
Acts as an interface to external readers (SREL3.EXT.*)
and other bus devices.
RS485
Serves as an interface to SimonsVoss WaveNet (sup-
LNI
port depends on firmware).
Signal
LED
Programming
Interfaces
SD card (memory: ≥ 2 GB. SD card must not be re-
Memory
moved or replaced)
Relay
2x, programmable independently from one another
Quantity
(support for second relay depends if firmware allows)
Programmable.
Switching modes
Switching interval Programmable between 0 s and 25 s.
Contact type
Contact material AgNi +Au
Service life (elec-
trics)
Service life
Typically 100 × 106 switching cycles
(mechanical)
Bounce time Typically 1 ms, max. 3 ms
Switching voltage 30 V
Switching current Max. 200 mA (ohmic load)
Digital inputs
Quantity 4
Level
12 | Technical specifications
– Connections: 3
– Baud rate: 1 MBd
– Length: ≤ 150 m, max. distance 300 m (depending
on firmware and cabling)
– 1 RGB
– 1 red
– TCP/IP
– USB
– External reader (supported if firmware allows)
– LNI (supported if firmware allows)
– Monoflop
– Flip-flop
– 1x NO
– 1x NC
– 12 V /1 mA: typ. 5 × 107 switching cycles
DC
– 6 V / 100 mA: typ. 1 × 107 switching cycles
DC
(ohmic load), 24 V
DC
– Low: 0 V to 0.5 V
DC
– High: 4 V to max. 30 V
DC
AC
DC
DC
123 / 135