Relay Option Mcb - Danfoss VLT AutomationDrive FC 300 Design Manual

Options and Accessories
1-00 Configuration Mode
1-01 Motor Control Principle
1-10 Motor Construction
1-24 Motor Current
1-25 Motor Nominal Speed
1-26 Motor Cont. Rated Torque
AMA is not possible on PM motors
1-30 Stator Resistance (Rs)
30-80 d-axis Inductance (Ld)
1-39 Motor Poles
1-40 Back EMF at 1000 RPM
1-41 Motor Angle Offset
17-50 Poles
17-51 Input Voltage
17-52 Input Frequency
17-53 Transformation Ratio
17-59 Resolver Interface
Table 9.4 Parameters to be Adjusted

9.5 Relay Option MCB 105

The MCB 105 includes 3 pieces of SPDT contacts and must be fitted into option slot B.
Electrical Data
Max terminal load (AC-1) 1) (Resistive load)
(Inductive load @ cosφ 0.4)
1)
Max terminal load (AC-15 )
1)
Max terminal load (DC-1) (Resistive load)
1)
Max terminal load (DC-13) (Inductive load)
Min terminal load (DC)
Max switching rate at rated load/min load
1)
IEC 947 part 4 and 5
When the relay option kit is ordered separately, the kit
includes:
•
Relay Module MCB 105
•
Enlarged LCP fixture and enlarged terminal cover
•
Label for covering access to switches S201 (A53),
S202 (A54) and S801
•
Cable strips for fastening cables to relay module
The relay option does not support FC 302 frequency
converters manufactured before week 50/2004.
Min. software version: 2.03 (15-43 Software Version).
®
VLT AutomationDrive FC 300 Design Guide 90-1200 kW
[1] Speed closed loop
[3] Flux with feedback
[1] PM, non salient SPM
Nameplate
Nameplate
Nameplate
Motor data sheet
Motor data sheet (mH)
Motor data sheet
Motor data sheet
Motor data sheet (usually zero)
Resolver data sheet
Resolver data sheet
Resolver data sheet
Resolver data sheet
[1] Enabled
DISMOUNT RELAY CARD TO ACCESS RS485
TERMINATION (S801) OR CURRENT/VOLTAGE
SWITCHES (S201, S202)
Illustration 9.9 A2, A3, and B3
MG34S202 - Rev. 2013-08-19
1
9 9
240 V AC 2 A
240 V AC 0.2 A
24 V DC 1 A
24 V DC 0.1 A
5 V 10 mA
-1 -1
6 min /20
231