Danfoss VLT AutomationDrive FC 300 Design Manual page 34

Product Introduction
Case 1. This case shows how reference input with limits inside Min to Max limits clamps.
3 3
Ext. Reference
Absolute
0 RPM 1 V
500 RPM 10 V
Digital input
Illustration 3.18 Positive Reference with Dead Band, Digital Input to Trigger Reverse
32
®
VLT AutomationDrive FC 300 Design Guide 90-1200 kW
General Reference
parameters:
Reference Range: Min - Max
Minimum Reference: 0 RPM (0,0%)
Maximum Reference: 500 RPM (100,0%)
Analog input 53
Low reference 0 RPM
+
High reference 500 RPM
Low voltage 1 V
High voltage 10 V
Ext. source 1
Range:
0,0% (0 RPM) Reference is scaled
according to min max
100,0% (500 RPM)
RPM
500
V
10
1
Digital input 19
Low No reversing
High Reversing
Limits Speed Setpoint
according to min max speed
MG34S202 - Rev. 2013-08-19
General Motor
parameters:
Limited to: -200%- +200%
Motor speed direction: Both directions
(-1000 RPM- +1000 RPM)
Motor speed Low limit: 0 RPM
Motor speed high limit: 200 RPM
Ext. reference
Reference
Range:
algorithm
0,0% (0 RPM)
100,0% (500 RPM)
Reference
Range:
0,0% (0 RPM)
100,0% (500 RPM)
reference giving a speed
Scale to
speed
Speed
setpoint
Range:
-500 RPM
+500 RPM
Motor PID
Motor
control
Limited to:
0%- +100%
(0 RPM- +500 RPM)
Dead band
RPM
500
V
10
1
-500
Range:
Motor
-200 RPM
+200 RPM