Danfoss VLT AutomationDrive FC 300 Design Manual page 68

Selection
FC 302
High/Normal load*
Typical shaft output at 550 V [kW]
Typical shaft output at 575 V [HP]
Typical shaft output at 690 V [kW]
Enclosure IP21, IP54 without/with options
cabinet
Output current
4 4
Continuous (at 550 V) [A]
Intermittent (60 s overload) (at 550 V) [A]
Continuous (at 575/690 V) [A]
Intermittent (60 s overload) (at 575/690 V) [A]
Continuous KVA (at 550 V) [KVA]
Continuous KVA (at 575 V) [KVA]
Continuous KVA (at 690 V) [KVA]
Maximum input current
Continuous (at 550 V) [A]
Continuous (at 575 V) [A]
Continuous (at 690 V) [A]
Max. cable size, motor [mm
Max. cable size, mains F2 [mm
Max. cable size, mains F4 [mm
Max. cable size, loadsharing [mm
Max. cable size, brake [mm
Max. external mains fuses [A]
Estimated power loss at 600 V [W]
Estimated power loss at 690 V [W]
F3/F4 Max added losses CB or disconnect &
contactor
Max panel options losses
Weight,
enclosure IP21, IP54 [kg]
Weight, rectifier module [kg]
Weight, inverter module [kg]
4)
Efficiency
Output frequency
Heatsink overtemp. trip
Power card ambient trip
* High overload=160% torque during 60 s, Normal overload=110% torque during 60 s.
Table 4.11 Technical Specifications, F2/F4 frames, 525-690 V Mains Supply 3x525-690 V AC
1) American Wire Gauge.
2) For fuse ratings, see 7.2.1 Fuses.
3) Typical power loss is at normal conditions and expected to be within
values are based on a typical motor efficiency (IE/IE3 border line). Lower efficiency motors add to the power loss in the frequency converter. If the
switching frequency is raised from nominal, the power losses rise significantly. LCP and typical control card power consumptions are included.
Options and customer load can add up to 30 W to the losses, though usually a fully loaded control card and options for slots A and B each add
only 4 W.
4) Measured using 5 m screened motor cables at rated load and rated frequency.
66
®
VLT AutomationDrive FC 300 Design Guide 90-1200 kW
HO
750
1050
900
988
1482
945
1418
941
941
1129
962
920
920
2 1)
(AWG) ]
2 1)
(AWG) ]
2 (AWG) 1) ]
2 (AWG) 1) ]
2 1)
(AWG) ]
2)
3) 4) 12062
3) 4) 12524
556
MG34S202 - Rev. 2013-08-19
P900 P1M0
NO HO
850 850
1150 1150
1000 1000
F2/F4 F2/F4
1108 1108
1219 1662
1060 1060
1166 1590
1056 1056
1056 1056
1267 1267
1079 1079
1032 1032
1032 1032
12x150 (12x300 mcm)
8x240 (8x500 mcm)
8x456 (8x900 mcm)
4x120 (4x250 mcm)
6x185 (6x350 mcm)
1600 2000
13731 13269
14250 13801
665 634
400
1260/1561
136 136
102 102
0.98
0-500 Hz
95 °C 105 °C
85 °C
± 15% (tolerance relates to variety in voltage and cable conditions.) These
P1M2
NO HO NO
1000 1000 1100
1350 1350 1550
1200 1200 1400
F2/F4
1317 1317 1479
1449 1976 1627
1260 1260 1415
1386 1890 1557
1255 1255 1409
1255 1255 1409
1506 1506 1691
1282 1282 1440
1227 1227 1378
1227 1227 1378
2500
16190 16089 18536
16821 16719 19247
863 861 1044
1294/1595
136
136
95 °C