Replacing And Adjusting The Y Slider Belt - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

4.2.3 Replacing and Adjusting the Y Slider Belt

Replacing the Y Slider Belt
(1) Remove the left and right side covers (see Subsection 4.1.1).
(2) Remove the top cover (see Subsection 4.1.3).
(3) As shown in Fig.4-16, loosen the spring adjustment plate.
• Tow M4 x L8 bind-head screws
(4) Loosen the tension of the Y slider belt.
• One M4 x L15 socket-head cap screw
(5) Remove the pen board (see Subsection 4.2.2).
Fig. 4-16
Fig. 4-17
4 - 7
FC3100-60 Service Manual
P/N53802-031T Rev. A