Setting The Dip Switches - GRAPHTEC CUTTING PRO FC3100-60 Service Manual

FC3100-60 Service Manual
P/N53802-031T Rev. A

5.4 Setting the DIP Switches

The NOVRAM CLEAR function
• Initializes the main board by clearing the nonvolatile RAM
• Execute this function before starting any electrical adjustment
Electrical adjustments
• Pen height adjustment
• Pen force adjustment
• Selection of Centronics compatible interface mode
Distance accuracy adjustment
• Perform this adjustment after clearing the nonvolatile RAM or after
replacing the main board
Sensor test
• After replacing a sensor, run this test to check its operation
Control panel key test
• After reconnecting the FPC cable to the relay board's J21 connector,
run this test to check the operation of the control panel keys.
Servo D/A ZERO OUT
• Offset adjustment of the X and Y motors
• Pen offset adjustment
5 - 4