GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 15

The prompt message below appears.
To select DUMP mode, press the [ 2 ] key to shift the blinking cursor next to ON.
If you decide not to select DUMP mode, press the [ 4 ] key to shift the blinking cursor to OFF.
↓
[ ENTER ] : Press the [ ENTER ] key.
↓
If DUMP mode has been selected, CHAR DUMP MODE appears on the display to indicate that the plotter
has entered DUMP mode.
↓
Transmit the data from the computer. As the data is received, the character data is printed as ASCII
codes and the non-character (control) data is plotted as two-digit hexadecimal values (e.g., Line Feed =
0A, Carriage Return = 0D, ETX = 03).
When all of the data has been printed, turn off the plotter to cancel DUMP mode.
2 - 5
FC3100-60 Service Manual
P/N53802-031T Rev. A