GRAPHTEC CUTTING PRO FC3100-60 Service Manual page 81

Temporarily Secure the Film Stocker Brackets
(1) Temporarily secure the Film Stocker Bracket to the Left Side Plate of the plotter using two M4 x
10mm Flat Head Screws.
(2) Temporarily secure the Film Stocker Bracket to the Right Side Plate using the same hardware.
Install the Film Stocker Rollers
(1) Slide the second roll guide onto the Film Stocker Roller from the right side. Temporarily secure it in
place using the second M4 Thumb Screw.
(2) Place the first Film Stocker Roller into the first roll guide slot on the left and right film stocker
brackets.
(3) Place the second Film Stocker Roller into the desired slot depending on the size of the media roll
being used.
Straighten and Tighten the Film Stocker Assembly
(1) Verify the Film Stocker Assembly is not skewed.
Fig. 4-101
Fig. 4-102
4 - 45
FC3100-60 Service Manual
P/N53802-031T Rev. A